Simrad AP24 Instrukcja Instalacji Pobierz pdf (Strona 12)

Operation | 11

2.6 AP24 and AP28 Control unit

installation

Avoid mounting the control unit(s) where it is easily

exposed to sunlight, as this will shorten the lifetime of

the display.

Do not install the control unit where moisture is

present at the rear. It may cause damage by

entering the breathing hole or by coming into

contact with the electrical connectors.

Panel mounting

The mounting surface must be flat and even to within 0.5

mm.

• Drill the 4 mounting holes and make a panel cut-out

according to supplied template.

• Connect the SimNet cable(s) to the control unit

connector(s)

• To daisy chain units remove the blocking plug with a

pair of pliers.

• Use the supplied 19 mm screws to fasten the control

unit to the panel.

• Apply the front panel corners.

Do not over-tighten the mounting screws!

Figure 2-5 AP24 Panel mounting

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 31 32

Brak uwag

Simrad AP24 Instrukcja Instalacji Strona 12