Simrad PI DEPTH Dokumentacja Strona 225
- Strona / 268
- Spis treści
- ROZWIĄZYWANIE PROBLEMÓW
- BOOKMARKI
Oceniono. / 5. Na podstawie oceny klientów
PI Configurator
213
857-164636 / Rev.A
Remote
This par ameter is only available for Spread, Twin Spread and
Remote sensors. The dialogue box allows selection of the
channels used to communicate between Spread and the Remote
sensors.
Note: These are key parameters when you work with Spread and
Remote sensors. Make sure the correct channels are selected for
all the sensors. Should incorrect parameters be chosen, the
sensors will not be able to communicate with each other, and the
PI Operator Unit will display “± ± ±”.
The Spread and Remote sensors must always be set up in sets as
follows:
Single trawl:
• Spread 1 must communicate with Remote 1
• Spread 2 must communicate with Remote 2
Twin trawl:
• Twin Spread 1 must communicate with Remote 1 and 3
• Twin Spread 2 must communicate with Remote 2 and 4
A Twin Spread sensor uses two channels to communicate
with the Remote sensors; one channel for each Remote.
Dual twin trawl:
• Twin Spread 1 must communicate with Remote 1 and 3
• Twin Spread 2 must communicate with Remote 2 and 4
To set up a dual twin trawl configuration, the two sets of
Twin Spread sensors must wor k with different
communication channels.
Operation
Use the Remote spin box, and select the desired channel or
channel combination. Click the Configure Sensor button to
program the interfaced sensor with the new channel parameter.
Check that the message field is updated with the new parameter
and the message Success!! displayed at the bottom as
confirmation that the command was executed.
- Operator manual 1
- Catch monitoring system 3
- About this document 4
- Sections 5
- 12 Sensor test procedures 6
- 13 Technical specifications 6
- Simrad PI32 10
- INTRODUCTION 13
- SYSTEM DESCRIPTION 14
- System diagram 15
- Operator Unit 16
- Sensor overview 18
- Battery chargers 19
- GETTING STARTED 20
- Power on 21
- Power off 21
- Page 1: Echo sounder 22
- Page 2: Numeric display 22
- Page 3: Graphic display 22
- Page 4: Navigation display 22
- Leafing through the pages 23
- Other display presentations 23
- Introduction to the main menu 24
- Introduction to the keypad 25
- Introducing the sensors 27
- Depth: How deep can you go? 29
- Rip: Check for damages! 30
- APPLICATION EXAMPLES 32
- Purse seine 33
- Danish seine 34
- Bottom trawl 35
- Pelagic trawl 36
- Echo sounder 37
- Graphic display 38
- DISPLAY PRESENTATIONS 39
- Numeric display 40
- Depth presentation 43
- Height presentation 44
- Spread presentation 45
- Surface temperature 49
- Status display 50
- → Receiver setup, page 174 51
- Echo sounder display 52
- Bottom expansion 53
- Navigation display 55
- Position display 56
- OPERATIONAL PROCEDURES 57
- → Numeric display, page 28 59
- How to set up the sensors 60
- Predefined settings 61
- How to use the sensors 64
- How to test the sensors 66
- How to define sensor offsets 68
- MENU Exit 72
- GAIN- GAIN+ 72
- (CD11105C) 72
- → Twin Spread, page 128 73
- → Trawl info, page 182 73
- Howtoviewechosounderdata 75
- How to set up marker lines 76
- Depth and Height marker lines 77
- Spread marker line 77
- → Graphic setup, page 160 78
- Access to the parameters 80
- Set up the parameters 80
- Ping to ping filter 82
- Colour threshold 82
- Signal threshold 82
- Depth grid 82
- Standard mode 84
- Phased range mode 84
- Activate A-Scope 88
- De-activate A-Scope 88
- How to define alarm limits 89
- Surface temperature alarm 90
- Clearance alarms 90
- How to select menu language 92
- → Page setup, page 171 93
- PRACTICAL USE OF THE SENSORS 95
- PI Bottom Contact sensor 99
- Bottom Contact presentatio n 100
- Sensor configuration 100
- System configuration 101
- Mounting 101
- 857-164636 / Rev.A 102
- PS Bottom Contact sensor 103
- PI Catch sensor 107
- Presentation 108
- PS Catch sensor 112
- Catch presentation 113
- PI Depth sensor 116
- Numerical presentation 117
- PS Depth sensor 121
- PI Height sensor 126
- Daily operation 127
- PI Rip sensor 130
- Numeric presentation 131
- PI Spread and Remote sensors 135
- Installation principle 138
- Sacrificial water switch 139
- PI Twin Spread 140
- Main parts 141
- PI Temperature sensor 145
- Temperature presentation 147
- PS Temperature sensor 151
- SENSOR CHARGERS 156
- PI Charger 157
- PS30 Charger 159
- General guidelines 160
- Battery depleted frequently 160
- Typical sensor (PI Depth) 160
- MENU SYSTEM 161
- The main menu 162
- Menu system 163
- REFERENCES 164
- Depth calibration 165
- Echo presentation setup 166
- Echo sounder setup 169
- Related topics 170
- Factory presets 171
- Graphic setup 172
- → Sensor setup, page 179 173
- → Numeric setup, page 169 173
- Interface setup NMEA 174
- Applicable telegram formats 177
- Interface setup remote/alarm 179
- Navigation setup 180
- Numeric setup 181
- Offset adjust 182
- Page setup 183
- Palette setup 184
- Position display setup 185
- Receiver setup 186
- Sensor alarms 189
- Sensor setup 191
- Speed setup 192
- Surface temperature setup 193
- Trawl info setup 194
- Units setup 195
- PI CONFIGURATOR 196
- Basic information 197
- Available equipment 198
- About sensor configuration 199
- Changing the update rate 200
- Main dialogue description 201
- Operational procedures 203
- Software installation 204
- How to interface the sensor 205
- References 210
- Communication P o rt Setup 212
- Operation 212
- Configure Sensor 213
- Factory Default 216
- Language 218
- LED Control 219
- Message field 220
- PI Configurator 221
- Ping control 222
- Read Sensor Data 224
- Sensor Type 226
- Show Channel At Startup 228
- Examples 229
- Terminate Communication 230
- Maintenance 231
- Making a programming cable 233
- Troubleshooting 234
- SENSOR TEST PROCEDURES 235
- Bottom Contact test procedure 236
- Testing on land 237
- Testing in water 237
- Catch sensor, test procedure 239
- Depth sensor, test procedure 242
- PI32 Calibration procedure 244
- PI44 Calibration procedure 244
- Height sensor, test procedure 245
- Tools and equipment required 248
- TECHNICAL SPECIFICATIONS 255
- PI Bottom Contact 256
- PI Catch & PI Rip 256
- PI Depth 257
- PI Height 258
- PI Spread & Remote 258
- PI Temperature 259
- - To 70% capacity: 1 hour 260
- - To 100% capacity: 4 hours 260
- - To 100% capacity: 16 hours 260
- E 2005 Simrad AS 268
- ISBN 82-8066-059-3 268
Powiązane produkty i podręczniki dla Nie Simrad PI DEPTH
Nie Simrad FS25 Podręcznik Użytkownika
(108 strony)
(108 strony)
Nie Simrad SP60 - REV D Instrukcja Użytkownika
(44 strony)
(44 strony)
Nie Simrad ER60 - REV B Informacje Techniczne
(256 strony)
(256 strony)
Nie Simrad ES38-10 - REV B Instrukcja Instalacji
(48 strony)
(48 strony)
Nie Simrad SH90 - REV B Dokumentacja
(2 strony)
(2 strony)
Nie Simrad PI HBU - REV A Instrukcja Obsługi
(12 strony)
(12 strony)
Nie Simrad SH80 - REV C Instrukcja Instalacji
(214 strony)
(214 strony)
Nie Simrad ITI Instrukcja Użytkownika
(36 strony)
(36 strony)
Nie Simrad SP60 - REV D Instrukcja Instalacji
(178 strony)
(178 strony)
Nie Simrad EQ 55 Informacje Techniczne
(154 strony)
(154 strony)
Nie Simrad SH80 - REV C Instrukcja Instalacji
(200 strony)
(200 strony)
Nie Simrad RS90 Instrukcja Użytkownika
(24 strony)
(24 strony)
Hinkley-lighting PIPER 4868BN manuales
Manuales del propietario y guías del usuario para Encendiendo Hinkley-lighting PIPER 4868BN.
Ofrecemos 1 manuales en pdf Hinkley-lighting PIPER 4868BN para descargar gratis por tipos de documentos: Manual de usuario
Hinkley lighting PIPER 4868BN Manual de usuario (1 paginas)
Marca: Hinkley-lighting | Categoria: Lighting | Tamaño: 0.31 MB |
Tabla de contenidos
06.01.11
1
Más productos y manuales para Encendiendo Hinkley-lighting
| Modelos | Tipo de documento |
|---|---|
| HAMLET FR42866VBZ |
Manual de usuario
 
Hinkley Lighting HAMLET FR42866VBZ User Manual,
3 paginas
|
| CASPIA FR43758SLF |
Manual de usuario
Hinkley Lighting CASPIA FR43758SLF User Manual,
1 paginas
|
| YORK 1845 |
Manual de usuario
Hinkley Lighting YORK 1845 User Manual,
3 paginas
|
| CONGRESS 3135 |
Manual de usuario
Hinkley Lighting CONGRESS 3135 User Manual,
1 paginas
|
| CHESTERFIELD 1381 |
Manual de usuario
Hinkley Lighting CHESTERFIELD 1381 User Manual,
2 paginas
|
| EVERLY 4200SH |
Manual de usuario
Hinkley Lighting EVERLY 4200SH User Manual,
2 paginas
|
| WINTON 5236 |
Manual de usuario
Hinkley Lighting WINTON 5236 User Manual,
2 paginas
|
| HAMPTON 3214AN |
Manual de usuario
Hinkley Lighting HAMPTON 3214AN User Manual,
2 paginas
|
| HAMPTON 3211AN |
Manual de usuario
Hinkley Lighting HAMPTON 3211AN User Manual,
2 paginas
|
| CHESTERFIELD 1382 |
Manual de usuario
Hinkley Lighting CHESTERFIELD 1382 User Manual,
3 paginas
|
| CASCADE 1830 |
Manual de usuario
Hinkley Lighting CASCADE 1830 User Manual,
2 paginas
|
| PLANTATION 4889BB |
Manual de usuario
Hinkley Lighting PLANTATION 4889BB User Manual,
3 paginas
|
| LUCERNE 2313 |
Manual de usuario
Hinkley Lighting LUCERNE 2313 User Manual,
2 paginas
|
| LEDGEWOOD 1122 |
Manual de usuario
Hinkley Lighting LEDGEWOOD 1122 User Manual,
2 paginas
|
| XANADU FR43352PSS |
Manual de usuario
Hinkley Lighting XANADU FR43352PSS User Manual,
1 paginas
|
| CHLOE 52400BN |
Manual de usuario
Hinkley Lighting CHLOE 52400BN User Manual,
3 paginas
|
| SEDGWICK 1771 |
Manual de usuario
Hinkley Lighting SEDGWICK 1771 User Manual,
2 paginas
|
| INDULGE FR34137BNI |
Manual de usuario
Hinkley Lighting INDULGE FR34137BNI User Manual,
3 paginas
|
| MERIDIAN 3874SK |
Manual de usuario
Hinkley Lighting MERIDIAN 3874SK User Manual [en] ,
3 paginas
|
| BRANTLEY 4637BN |
Manual de usuario
Hinkley Lighting BRANTLEY 4637BN User Manual,
2 paginas
|
© 2020, manymanuals.pl. Wszelkie prawa zastrzeżone. | 0.022 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Komentarze do niniejszej Instrukcji