Simrad PI54 A Dokumentacja Strona 178
- Strona / 322
- Spis treści
- ROZWIĄZYWANIE PROBLEMÓW
- BOOKMARKI
Oceniono. / 5. Na podstawie oceny klientów
Simrad PI54
166
850-165186 / Rev.B
Indicators
(A) =Mains:12to32Vdc
(B) = Fuel meter. The number of LEDs illuminated shows the
current charging status. A complete charging cycle is indicated
with all “full” battery. Charging:
Fast:Fastflash
Normal: Slow flash
Trickle: On, off every 4 second
(C) = Battery temperature indicators during fast charging:
Green: Battery temperature between +5 and +40°C. Fast
charge is enabled.
Green and Blue: Battery temperature between 0 and +5°C.
Fast charge is disabled, normal charge is used.
Green and Red: Battery temperature between +40 and
+50°C. Fast charg disabled, normal charge is used.
Blue: Battery temperature is below 0°C. No charging takes
place.
Red: Battery temperature is above +50°C. No charging takes
place.
Warning: Charging a sensor at sub-zero temperature might
develop explosive gases r epresenting a potential
danger. Simrad assumes no liability for improper
charging, o r the use of other chargers than those
approved by Simrad.
Automatic configuration
The charger communicates with the sensor at regular intervals.
The fast charge cycle is controlled by data exchanged between
the PI sensor and the charger, and a series of safety mechanisms
controls the t ermination of the fast charging current.
The PS sensors do not communicate with the charger. A
constant charge current of 58 mA is then set up by the charger
regardless of the battery temperature.
Typical sensor (PI Depth)
(A) = Negative charging / fastening lug
(B) = Positive charging / fastening lug
(C) = Communication link
(D) = Location of sensor lamp
(E) = Water switch sensor
(F) = Water pressur e sensor
- Operator manual 1
- Catch monitoring system 3
- About this document 4
- Sections 5
- 12 Sensor test procedures 6
- 13 Technical specifications 6
- 14 Software updates 6
- Simrad PI54 10
- INTRODUCTION 13
- Changes to this manual 14
- SYSTEM DESCRIPTION 15
- System diagram 16
- Operator Unit 17
- Sensor overview 19
- Battery chargers 20
- GETTING STARTED 21
- Power on 22
- Power off 22
- Pages and Windows 23
- To set up a presentation page 23
- To define window information 24
- Window sizes and information 24
- Page 1: Echo sounder 25
- Page 2: Numeric display 25
- Page 3: Graphic display 26
- Page 4: Navigation display 26
- Leafing through the pages 27
- Other display presentations 27
- Introduction to the main menu 28
- Introduction to the keypad 29
- Introducing the sensors 32
- Depth: How deep can you go? 34
- Rip: Check for damages! 35
- APPLICATION EXAMPLES 37
- Purse seine 38
- Danish seine 39
- Bottom trawl 40
- Pelagic trawl 41
- Echo sounder 42
- Graphic display 43
- DISPLAY PRESENTATIONS 44
- Numeric display 45
- Depth presentation 49
- Height presentation 50
- Spread presentation 51
- Surface temperature 57
- Status display 58
- (A) Numeric information 59
- (B) Upper status field 59
- (C) Frequency spectrum 60
- (D) Gain indicators 60
- (E) Lower status field 61
- → Receiver setup, page 208 61
- → Status setup, page 218 61
- Echo sounder display 62
- Bottom expansion 63
- Highway display 65
- Position display 66
- OPERATIONAL PROCEDURES 67
- → Numeric display, page 33 69
- How to set up the sensors 70
- Predefined settings 71
- How to use the sensors 74
- How to test the sensors 76
- How to define sensor offsets 78
- MENU Exit 82
- GAIN- GAIN+ 82
- (CD11105C) 82
- → Twin Spread, page 148 83
- → Trawl info, page 223 83
- Readout adjustments 89
- Readouts 89
- Howtoviewechosounderdata 92
- How to set up marker lines 93
- Depth and Height marker lines 96
- 850-165186 / Rev.B 100
- Ping to ping filter 101
- Colour threshold 101
- Signal threshold 101
- Depth grid 101
- Phased range mode 103
- Access to the dialogue 103
- Standard mode 103
- Related topics 104
- Activate A-Scope 107
- De-activate A-Scope 107
- How to define alarm limits 108
- Surface temperature alarm 109
- Clearance alarms 109
- How to select menu language 111
- → Page setup, page 204 112
- PRACTICAL USE OF THE SENSORS 115
- Sensor configuration 116
- PI Bottom Contact sensor 119
- Bottom Contact presentation 120
- System configuration 121
- Mounting 121
- PS Bottom Contact sensor 123
- PI Catch sensor 127
- Presentation 128
- PS Catch sensor 132
- Catch presentation 133
- PI Depth sensor 136
- Numerical presentation 137
- PS Depth sensor 141
- PI Height sensor 146
- Daily operation 147
- PI Rip sensor 150
- Numeric presentation 151
- PI Spread and Remote sensors 155
- Installation principle 158
- Sacrificial water switch 159
- PI Twin Spread 160
- Main parts 161
- PI Temperature sensor 165
- Temperature presentation 167
- PS Temperature sensor 171
- SENSOR CHARGERS 176
- PI Charger 177
- PS30 Charger 179
- General guidelines 180
- Battery depleted frequently 180
- Typical sensor (PI Depth) 180
- MENU SYSTEM 181
- ECHO SOUNDER WIN 182
- Menu system 183
- Echo quick menu 184
- REFERENCES 185
- Setup map 186
- References 187
- Depth calibration 188
- Echo presentation setup 189
- Echo sounder setup 192
- Echo sounder parameters 193
- Factory presets 195
- Graphic setup 196
- → Sensor setup, page 215 198
- → Numeric setup, page 202 198
- Interface setup 199
- PI Function 201
- Position 202
- Navigation 203
- Identification 206
- Applicable telegram formats 207
- Marker line setup 209
- → Graphic display, page 41 211
- → Graphic setup, page 184 211
- → Trawl calculator, page 221 211
- Navigation setup 212
- Numeric setup 214
- Offset adjust 215
- Page setup 216
- Palette setup 217
- Position display setup 218
- Quick guide 219
- Receiver setup 220
- Sensor alarms 223
- Surface temperature alarms 225
- Sensor setup 227
- Speed setup 229
- Status setup 230
- Surface temperature setup 231
- Temperature setup 232
- Trawl calculator 233
- → Marker line setup, page 197 234
- Trawl info setup 235
- Units setup 237
- PI CONFIGURATOR 238
- Basic information 239
- Available equipment 240
- About sensor configuration 241
- Changing the update rate 242
- Main dialogue description 243
- Operational procedures 245
- Software installation 246
- How to interface the sensor 247
- Communication Port Setup 254
- Operation 254
- Configure Sensor 255
- Factory Default 258
- Language 260
- LED Control 261
- Message field 262
- PI Configurator 263
- Ping control 264
- Read Sensor Data 266
- Sensor Type 268
- Show Channel At Startup 270
- Examples 271
- Terminate Communication 272
- Maintenance 273
- Making a programming cable 275
- Troubleshooting 276
- SENSOR TEST PROCEDURES 277
- Bottom Contact test procedure 278
- Testing on land 279
- Testing in water 279
- Tools and equipment required 281
- Catch sensor, test procedure 285
- Depth sensor, test procedure 288
- PI32 Calibration procedure 290
- PI44 Calibration procedure 290
- Height sensor, test procedure 294
- TECHNICAL SPECIFICATIONS 297
- PI Bottom Contact 298
- PI Catch & PI Rip 298
- PI Depth 299
- PI Height 300
- PI Spread & Remote 300
- PI Temperature 301
- - To 70% capacity: 1 hour 302
- - To 100% capacity: 4 hours 302
- - To 100% capacity: 16 hours 302
- SOFTWARE UPDATES 303
- DSP Software upgrade 304
- The program file 305
- Procedure 305
- Messages 306
- Safety measures 306
- Critical process 307
- MMI Software upgrade 308
- PI DSP Upload 311
- E 2005 Simrad AS 322
- ISBN 82-8066-053-4 322
Technoline WS 9611-IT Handbücher
Bedienungsanleitungen und Benutzerhandbücher für Wetterstationen Technoline WS 9611-IT.
Wir stellen 1 PDF-Handbücher Technoline WS 9611-IT zum kostenlosen herunterladen nach Dokumenttypen zur Verfügung Bedienerhandbuch
Technoline WS 9611-IT Bedienerhandbuch (39 Seiten)
Marke: Technoline | Kategorie: Weather stations | Größe: 0.31 MB |
Inhaltsverzeichnis
Weitere Produkte und Handbücher für Wetterstationen Technoline
| Modelle | Dokumententyp |
|---|---|
| WS 1600 |
Bedienerhandbuch
Technoline WS 1600 weather station,
54 Seiten
|
| WS 6720 |
Bedienerhandbuch
Technoline WS 6720 weather station,
5 Seiten
|
| WS 2800-IT |
Spezifikationen
Technoline WS 2800-IT weather station,
31 Seiten
|
| WS 2350 |
Spezifikationen
Technoline WS 2350 weather station,
44 Seiten
|
| WT 514 |
Handbuch
Technoline WT 514 weather station,
2 Seiten
|
| WS 8117 |
Bedienerhandbuch
Technoline WS 8117 weather station,
12 Seiten
|
| WS 9260 |
Spezifikationen
Technoline WS 9260 weather station,
10 Seiten
|
| WS 9032 |
Bedienerhandbuch
Technoline WS 9032 weather station,
8 Seiten
|
| WS 9121 |
Handbuch
Technoline WS 9121 weather station,
1 Seiten
|
| WS 7037 | Bedienungsanleitung Technoline WS 7037 weather station, 2 Seiten |
| WS 6810 |
Bedienerhandbuch
Technoline WS 6810 weather station,
1 Seiten
|
| WS 9116 |
Spezifikationen
Technoline WS 9116 weather station,
2 Seiten
|
| WS 9040 IT |
Bedienerhandbuch
Technoline WS 9040 IT weather station [en] ,
44 Seiten
|
| WS 7208 |
Spezifikationen
Technoline WS 7208 weather station,
10 Seiten
|
| WS 9140-IT |
Bedienerhandbuch
Technoline WS 9140-IT weather station,
29 Seiten
|
© 2020, manymanuals.pl. Wszelkie prawa zastrzeżone. | 0.041 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Komentarze do niniejszej Instrukcji